Cultivator - Entry set (KIT)

In this manual we will look at the installation of the cultivator in the entry set (kit variant). It will take you about half an hour to assemble the entire cultivator and you will understand its design.

You will need the usual tools you will find in your workshop. In particular you will use:

• Allen key set
• M3 wrench (Size 5,5)
• Tweezers or small nose pliers

General

Here is the entire video with the complete assembly of the cultivator.

Unless otherwise stated, the screws are lightly tightened. In most cases, these are M2 bolts and can be pulled off easily. Other package specifications, which may vary depending on the option chosen, are marked (...)

Coulters assembly

1. Using two M2x8 bolts and two M3 nuts, secure the coulter between the two holders. The coulter can be attached to the holder in three positions, i.e. in the holes except the outermost one.
2. Repeat the procedure for all coulters.
3. The top hole at the holder is used to attach the lever. Connect the lever to the holder with an M2x8 bolt and M2 nut. Repeat the procedure for all coulters.

Attaching the coulters to the main frame

1. The coulters are attached to the main frame in two places. First, add the lever to the frame with an M2x8 bolt and M2 nut. Then push the M2x8 bolt through the holder, through the bottom mount on the frame and the other holder. Secure with the bolt and M2 nut.
2. Repeat the procedure for all coulters.

Tip 1: Move from the middle coulter towards the edges.

Tip 2: If your cultivator has a rear frame, it is easier to add it after adding three center coulters.

Three-point linkage

1. Screw M3x8 screws into the side holes
2. Screw M3x16 screws into the selected holes on the TPL legs from the inside
3. Attach the TPL to the main frame with M3x10 screws. Use the lower edge holes and the upper hole on the TPL.